8 Woodworking Hacks You Won’t Believe You’ve been Living Without
In the world of DIYing, we're always in demand to some hacks to assistance us save money, time or effort (or all three!), without compromising on quality or safety, of grade. So here are some seriously helpful hacks to implement when you lot're working with wood and drills. Don't have the right size drill bit? No clamp? Need to fill a hole in the wall? All these problems tin can exist solved with these awesome tips.
Video
1. Makeshift Drill Bit
If you don't have the correct size drill bit for a hole that yous need to drill you can actually just use a smash instead. Take the boom that you're planning on using, clip off the head, attach information technology to the drill and just use that as the drill bit.
2. No-Clench Gluing – Side-by-Side
If you accept to glue some pieces of wood together for a elevation but don't have a clamp, take ii pieces of scrap wood and attach them to a work surface a little fleck further apart than the size of the pieces that are being glued. Put the wood pieces in the gap and then utilise two wedges to fill the open up gap.
iii. Wax Paper Cut (#2 continued)
Keep any gum from getting on your work surface by putting down a piece of wax newspaper underneath the wood that's being glued. No pair of scissors to cut the newspaper? But use a metal straight edge (like a ruler) to tear it straight.
4. No-Clamp Gluing – On Top of One Another
If you're gluing pieces together on top of each other like for a leg, for example, you tin substitute C-shapes for a clamp. The same idea applies as in number two: brand the gap of the C-shape a chip bigger than the pieces that are being glued and so use smaller wedges to fill the gap and keep the pieces in place.
5. Salt Gum Trick (#four continued)
When gluing the pieces to each other, you may detect that they slip effectually a bit while trying to clamp them in place. After applying the glue, sprinkle just a picayune flake of regular table table salt before placing them together – it'll prevent whatever of that movement.
6. Drilling a 90° Hole
Without a drill press, drilling a 90° hole can be quite tricky. There is a way to do it as close to 90° as possible, though. Stack together two pieces of dimensional lumber with one piece sticking up a lilliputian scrap higher so that information technology creates a corner with a correct angle. Identify your drill right against that corner and drill away!
If you practice have a drill printing simply can't fit the piece of wood, drill the hole into a piece of scrap wood. Then attach the same drill bit to your hand drill, run it through the hole in the scrap piece and use that nearly like a stencil or guide to drill through the piece that you actually demand.
7. Sharpening Blades
A blunt utility knife isn't very helpful when working with forest, just what do yous practice without a sharpener? Take a regular ceramic mug, plow it upside-down and scrape the bract against the bottom rim just as yous would with a sharpening stone.
8. Filling a Hole
When removing a nail from the wall where a painting used to hang, you're left with that hole in the wall. Instead of driving to the store and spending money on spackle, just employ some toothpaste. Later on well-nigh ii hours of drying you can paint correct over it and no ane would e'er know!
Video by Izzy Swan Youtuber.
Source: https://www.diyncrafts.com/12067/lifehacks/8-woodworking-hacks-you-wont-believe-youve-been-living-without
0 Response to "8 Woodworking Hacks You Won’t Believe You’ve been Living Without"
Post a Comment